Scratch/Chip

Before starting your repair, you need to remove all high points and burrs with a chisel.

Once this is done, melt the appropriate hardwax plus into the damaged area making sure to overfill.

After allowing the wax to cool down, you need to remove all excess filler with the special applicator before smoothing off the surface using 1200 grit ready for spraying.

Apply 3-4 light coats of the chosen covering lacquer until you cannot see the repair anymore.

After the spraying is complete, we must lightly sand down some of the excess spray using 1200 grit and plenty of water.

Finally polish up the profile with the polishing paste and the repair is complete.